OWC Mercury Rack Pro Uživatelská příručka stáhnout pdf (Strana 10)

2.3 Connections to Computer

Power Input

Voltage Switch

eSATA

USB 3.0

FW400

FW800

Cable Connections:

➀ Plug the power cable into the wall and into the OWC Mercury Rack Pro.

➁ Connect the eSATA, FireWire 800, FireWire 400, or USB 3.0 cable - appropriate for the

interface your computer supports - into the drive and computer. (eSATA recommended

for maximum performance)

If sold as a precongured solution, your OWC Mercury Rack Pro is preset as a RAID 5,

using the “Mac OS Extended” format and is ready to use. If you want to change this

conguration, please follow the instructions in Chapter 3 to do so.

A few precautions and notes when using your external storage device:

• Do not expose the product to water or humid conditions.

• Do not cover the enclosure’s ventilation holes.

• Only one interface (eSATA, FW800, FW400, USB 3.0) at a time can be used.

• When more than one interface cable is connected, the fastest interface has

priority. To use a dierent interface, dismount the drive from the computer via the

operating system, then disconnect the interface cable you are changing from rst

before connecting the new interface cable.

• Before connecting the device to your computer, install the drives, and set your

preferred RAID mode.

• For the safe removal of your drive and to assure that no data is lost, always eject or

unmount the drive from your operating system before powering o. See section

4.2 for that procedure.

• In order for the computer to access volumes larger than 2TB, the Operating

System need to support large volumes (e.g.: Windows Vista 32bit/64bit or Mac OS

X 10.4 and above).

OWC Mercury Rack Pro Chapter 2 - System Setup

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Žádné komentáře

OWC Mercury Rack Pro Uživatelská příručka Strana 10